This article explains the Standard Procedure for Rescue of a Surface-Supported Diver. This article covers CPR and identification of lost divers. Before you attempt a dive rescue, it is best to obtain a complete certification. If you have a full certification, you will be able save the lives of others divers in an emergency. It also discusses the importance of locating the victim as well as performing CPR on an unconscious diver.
Standard procedure to rescue surface diver
Rescuers must immediately respond to any difficulty a surface-supplied diver may be experiencing and transport him or her safely to safety. This is usually a diving bell or area where the diver cannot drown and where first aid can be administered. However, there are times when it may not be possible to reach the diver through the bell, so rescue divers must modify their response to meet the situation.
Securing the umbilicals is the first step to rescue. The bell should be ejected by the diver at the place where the umbilical enters. The surface tender should then follow in the footsteps of the diver's umbilical as it leaves the bell. Depending on which bell you have, the diver might also be supplied via the umbilicals within the bell. To prevent them from slipping, the umbilicals should be secured.
The diver's tender and the diving supervisor should give directions to the rescuers. The standby diver will perform some other tasks while the diver is being rescued but must still be able to provide emergency assistance to the diver. It is vital to maintain constant contact with the diver during this procedure.
Identifying a lost diver
It can be hard to identify a missing diver. But there are many ways you can find him. First, contact the local authorities. In this instance, the diver was reported missing June 17th in Mukilteo Washington. Police and fire departments responded immediately to the call. Coast Guard and sheriff's divers searched the area. They were unable to locate Korompis or his partner.
Another option for finding a lost diver is to use a MOB device. This device sends out a distress message using an underwater radio frequency. However, the device is only functional if the signal is received by nearby vessels. It is highly recommended that this device be used, however it is not always possible. Some boats do not have AIS technology. They will not be able find a lost diver. However, if the vessel does have an AIS system, it will allow SAR services to find the diver and assist them.
CPR on an inresponsive diver
CPR may be used to revive a diver that isn't breathing. Open the airway by sliding your hand underneath the diver's arm or by reaching up and holding the diver's breathing equipment. Then pinch the nose of your diver and gently roll him or her toward you. Give two rescue breaths if breathing stops. Repeat the process two to three more times.
It is important that you don't attempt to rescue the diver's bell during CPR. This could cause blood to pool. Continue rescue breathing until the diver regains consciousness. The diver may need to be transferred to a decompression chamber. Although it may seem difficult to perform CPR on an unconscious diver, it is essential.
You can use positive buoyancy to bring the diver to safety if you are able to see his pulse. This will let you assess the condition of your diver and determine whether he requires rescue breathing. If the diver is not breathing you can alternate between two rescue breaths and 30 chest compressions. Alternate your breathing for a maximum period of 30 seconds.